Code CR1000 Manuale Utente Scaricare il pdf (Pagina 12)

C005905_03_CR1000_User_Manual

16.0 - Reader Pinouts

The connector on the CR1000 is an RJ-50 (10P-10C). The pinouts are as follows:

Pin 1 +VIN (5v)

Pin 2 USB_DM

Pin 3 USB_DP

Pin 4 RS232 TX (output from reader)

Pin 5 RS232 RTS (output from reader)

Pin 6 RS232 RX (input to reader)

Pin 7 RS232 CTS (input to reader)

Pin 8 External Trigger (acve low input to reader)

Pin 9 N/C

Pin 10 Ground

The CR1000 device needs only a minimum of maintenance to operate. A few ps are given below for maintenance suggesons.

Cleaning the CR1000 Window

The CR1000 window should be clean to allow the best performance of the device. The window is the clear plasc piece inside

the head of the reader. Do not touch the window. Your CR1000 uses CMOS technology that is much like a digital camera. A dirty

window may stop the CR1000 from reading bar codes.

If the window becomes dirty, clean it with a so, non-abrasive cloth or a facial ssue (no loons or addives) that has been

moistened with water. A mild detergent may be used to clean the window, but the window should be wiped with a water moistened

cloth or ssue aer using the detergent.

The following agents are approved to clean a Code bar code reader:

1) Alcohol Wipes

2) CaviWipes® Disenfecng Towlees

3) Clorox® Disenfecng Wipes

4) Clorox Bleach Soluon (10% clorox bleach, 90% tap water)

5) Medical DiAirKem

6) Sani-Cloth® HB, Super Sani-Cloth® Germicidal, Sani-Cloth® Plus Germicidal Disposable Wipes

7) Virex® II Disinfectant Cleaner

Technical Support and Returns

For returns or technical support call Code Technical Support at (801) 495-2200. For all returns Code will issue an RMA number which

must be placed on the packing slip when the reader is returned.

Visit hp://www.codecorp.com/codesupport.php for more informaon.

17.0 - CR1000 Maintentance

1 2 ... 7 8 9 10 11 12 13

Nessun commento

Code CR1000 Manuale Utente Pagina 12